Mechanical Assembler 3rd Shift

Job Req ID:41560
Work Type: Onsite
Department: MFG

What you’ll do:

•   You will work from prints, method sheets, operation sheets, specification sheets, sketches, and/or verbal instructions to produce parts in accordance with acceptable quality and quantity levels.
•   You will set up and operate small lathes, automatic machines, drill presses, lapping machines, pneumatic drill presses, hydraulic presses, and markings. Perform hydraulic tests on parts and assemblies as specified in methods and verbal instructions in the K Department.
•   You will perform a variety of secondary machining operations such as turning, boring, chamfering, counterboring, and general assembly work. Prepare, sandblast components, and run spot welding machine. Setup by others.
•   You will use micrometers, Vernier’s, vacuum check, monochromatic light, optical flat, stops and guides, plug gages, expansion plugs and indicators. Set speeds and feeds, tools, depth gauges, comparators, and similar instruments.
•   You will machine fixtures, jaws, plugs, and similar parts. Change and reset dull tooling as required. Charge table plates with diamond paste following prescribed methods. Repair parts and finished seals as instructed or directed by the Supervisor
•   You will be responsible for checking your work after the first piece check by the Supervisor.
•   You will report faulty operation, defective material, and unusual conditions to the Supervisor. 

Qualifications:
Basic Qualifications:

•   Minimum of High School Diploma or GED from an accredited institution
•   Must be able to work in the United States without corporate sponsorship now and in the future
•   This position requires the use of information or access to hardware that is subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident (i.e., 'Green Card Holder'), Political Asylee, or Refugee.
•   No relocation benefit is being offered for this position. Only candidates within a 50-mile radius of Rumford, RI will be considered. Active-duty military Service member candidates are exempt from the geographical area limitation.
 
Preferred Qualifications: 
 
•   Ability to read and interpret complicated drawings, specifications, charts, tables
•   Experience with precision measurement instrumentation
•   Knowledgeable in GD&T